Specifications
Table Of Contents
- HP ProLiant ML350 Generation 4 Server Maintenance and Service Guide
- Notice
- Contents
- Illustrated parts catalog
- Removal and replacement procedures
- Required Tools
- Safety considerations
- Preparation procedures
- Removing tower feet
- Removing the front bezel (tower model)
- Rack rails
- Removing the power supply blank
- Hot-plug power supply
- Non-hot-plug power supply
- Hot-Plug Power Supply Backplane
- Removing a hard drive blank
- Hot-Plug SCSI Hard Drive
- Non-hot-plug SCSI hard drive
- Redundant system fan
- Expansion Slot Cover
- Expansion board
- CD-ROM drive
- Tape drive
- Internal two-bay hot-plug SCSI drive cage
- Processor and Heatsink
- PPM
- Second serial port
- Duplex SCSI backplane
- Battery
- System Board
- Re-entering the server serial number and product ID
- Diagnostic tools
- Server component identification
- Specifications
- Acronyms and abbreviations
- Index
Removal and replacement procedures 28
NOTE: PPM 1 is embedded onto the system board.
NOTE: The appearance of compatible PPMs may vary.
To replace the component, reverse the removal procedure.
Second serial port
To remove the component:
1. Remove the access panel ("Access Panel" on page 12).
2. Open the retention clip securing the second serial port.
3. Remove the serial port cable from the serial port header on the system board.
4. Remove the second serial port option.
To replace the component, reverse the removal procedure.