Command Reference Guide

Information Menu 34
Show all FDB information
Command: /info/l2/fdb/dump
MAC address VLAN Port Trnk State
----------------- ---- ---- ---- -----
00:02:01:00:00:00 300 1 TRK
00:02:01:00:00:01 300 23 FWD
00:02:01:00:00:02 300 23 FWD
00:02:01:00:00:03 300 23 FWD
00:02:01:00:00:04 300 23 FWD
00:02:01:00:00:05 300 23 FWD
00:02:01:00:00:06 300 23 FWD
00:02:01:00:00:07 300 23 FWD
00:02:01:00:00:08 300 23 FWD
00:02:01:00:00:09 300 23 FWD
00:02:01:00:00:0a 300 23 FWD
00:02:01:00:00:0b 300 23 FWD
00:02:01:00:00:0c 300 23 FWD
An address that is in the forwarding (FWD) state indicates that the switch has learned it. When in the trunking (TRK)
state, the Trnk field displays the trunk group number. If the state for the port is listed as unknown (UNK), the MAC
address has not yet been learned by the switch, but has only been seen as a destination address. When an address
is in the unknown state, no outbound port is indicated.
Clearing entries from the forwarding database
To delete a static MAC address from the forwarding database (FDB), see the “Static FDB configuration” section in the
“Configuration Menu” chapter. To clear the entire forwarding database (FDB), see the “Forwarding Database
options” section in the “Maintenance Menu” chapter.
Link Aggregation Control Protocol information
Command: /info/l2/lacp
[LACP Menu]
aggr - Show LACP aggregator information for the port
port - Show LACP port information
dump - Show all LACP ports information
The following table describes the Link Aggregation Control Protocol Menu options.
Table 20 LACP information
Command Usage
aggr
Displays LACP aggregator information for the port.
port
Displays LACP information for the port.
dump
Displays all LACP information parameters.