Command Reference Guide

Statistics Menu 81
Table 67 VRRP statistics
Field Description
vrrpBadInterval The total number of VRRP advertisements that had a bad interval.
RIP statistics
NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Command: /stats/l3/rip
RIP ALL STATS INFORMATION:
RIP packets received = 12
RIP packets sent = 75
RIP request received = 0
RIP response received = 12
RIP request sent = 3
RIP response sent = 72
RIP route timeout = 0
RIP bad size packet received = 0
RIP bad version received = 0
RIP bad zeros received = 0
RIP bad src port received = 0
RIP bad src IP received = 0
RIP packets from self received = 0
Management Processor statistics
Command: /stats/mp
[MP-specific Statistics Menu]
pkt - Show Packet stats
tcb - Show All TCP control blocks in use
ucb - Show All UDP control blocks in use
cpu - Show CPU utilization
The following table describes the Statistics Menu options for the management processor (MP):
Table 68 MP-specific Statistics Menu
Command Usage
pkt Displays packet statistics, to check for leads and load.
tcb Displays all Transmission Control Protocol (TCP) control blocks (TCB) that are in use.
ucb Displays all User Datagram Protocol (UDP) control blocks (UCB) that are in use.
cpu Displays CPU utilization for periods of up to 1, 4, and 64 seconds.
Packet statistics
Command: /stats/mp/pkt
Packet counts:
allocs: 36692 frees: 36692
mediums: 0 mediums hi-watermark: 3
jumbos: 0 jumbos hi-watermark: 0
smalls: 0 smalls hi-watermark: 2
failures: 0