HP Designjet 4000 Printer Series - Setup instructions

Close the ink cartridge door.

Wait (about a minute) until you see this front

panel message.

Lift up the cover. This will give you access to the

setup printheads.

Open the printer window.

To remove a setup printhead, lift up the blue

handle.

Before removing the setup printheads, look at the

window on top of each one and check that the

printhead contains ink.

Pull up and release the latch on top of the

carriage assembly.

Using the blue handle, gently disengage the setup

printhead from the carriage..

Lift the setup printhead until it is released from

the carriage assembly. Then remove the other

setup printheads.

8 Removing setup printheads

Position the ink cartridge at the rear of the drawer

as indicated.

Push the ink cartridge drawer back into the

printer until it locks into position.

Following the same instructions, install the other

three ink cartridges.

Remove the packing tape that is holding down

the printhead carriage latch.

Place the ink cartridge onto the ink cartridge

drawer. Note that there are marks on the drawer

showing the correct location.