HP LaserJet 4200 and 4300 printers - Software Technical Reference Manual

Width and height controls
The width and height values can be changed either by typing numeric strings into the edit boxes, or by using the up
and down arrows.
Any entry that is greater than the maximum limits of the width and height control is rounded down to the maximum
valid entry, while any entry that is smaller than the minimum limits of the width and height control is rounded up to the
minimum valid entry. See "Custom width and height control limits."
If units are in millimeters, the custom paper-size range minimum is the limit rounded up to the nearest whole millimeter.
The custom paper-size range maximum is the limit rounded down to the nearest whole millimeter. Any non-numerical
entry reverts to the last valid entry. Width and height entries are validated when the focus has changed.
The resolution of each control is one millimeter or one-tenth of an inch, depending on the current measurement units.
Clicking the up and down arrows increases or decreases the current value by the increment amount (within the allowed
range of values). The computer determines the rate at which the values change.
Unit indicator labels change dynamically to indicate inches or millimeters, depending on the measurement units the
driver is currently using. To change measurement units, click the Measurement Units button.
Custom width and height control limits
The minimum paper size for the HP LaserJet 4200 and 4300 series printers is 98 mm by 191 mm (3.87 inches by 7.5
inches) and the maximum is 216 mm by 356 mm (8.5 inches by 14.0 inches). The following table summarizes paper
size limits for each paper-handling device.
Table 10: Custom width and height limits for the HP LaserJet 4200 and 4300 series printers
Media source or paper-handling
accessory
Minimum size - width by heightMaximum size - width by height
Tray 1 (multipurpose) 98 mm by 191 mm
(3.9 inches by 7.5 inches)
312 mm by 470 mm
(12.28 inches by 18.46 inches)
Tray 2 148 mm by 210 mm
(3.9 inches by 7.5 inches)
297 mm by 432 mm
(11.7 inches by 17.0 inches)
Tray 3 148 mm by 210 mm
(3.9 inches by 7.5 inches)
297 mm by 432 mm
(11.7 inches by 17.0 inches)
Duplex printing accessory 98 mm by 191 mm
(3.9 inches by 7.5 inches)
312 mm by 470 mm
(12.28 inches by 18.46 inches)
500-sheet stapler/stacker face-up bin 98 mm by 191 mm
(3.9 inches by 7.5 inches)
312 mm by 470 mm
(12.28 inches by 18.46 inches)
1,500-sheet stapler/stacker face-down bin 148 mm by 210 mm
(3.9 inches by 7.5 inches)
312 mm by 470 mm
(12.28 inches by 18.46 inches)
Tray 4 148 mm by 210 mm
(3.9 inches by 7.5 inches)
297 mm by 432 mm
(11.7 inches by 17.0 inches)
Paper and envelope icons
The paper and envelope icons visually define width and height.
Measurement Units button
Like the dynamic command button previously described, the Measurement Units button is also multititled, although its
function is always to toggle the unit of measurement between standard (inches) and metric (millimeters) units of
measurement.
Software Technical Reference Driver features 67