HP LaserJet 4200 and 4300 series printer - Start Guide

English

15
Note: If the configuration page does not print, make sure that there are no
messages (other than READY) on the control panel display, that the Ready
light (top light) is on, and that no other lights are on or blinking. Make sure
that paper is loaded and that the paper tray is properly adjusted. Make
sure that the print cartridge is installed correctly.
Install the printing software. Procedures for software installation vary
according to the operating system and the network environment. Insert
the CD-ROM into the CD-ROM drive. When the installation wizard starts,
follow the instructions. See the Readme (read4300) on the CD-ROM if the
installation wizard does not start or for detailed installation information.
@801»¯°±dqKÿÿL³ @READY
e´µfñ¶E´µÉ· @OøÉ·E¸%9ÄÉ·Ï¸
\<¹qK/±°%3qº±¢qK¡¢3q
A!i1j£»Ò¼Ã½¾¿rsÀÁ<§¨©ª«<A/
§¨©ª«<g:Âáéd45É²ÂÃ;
¡dMN<§¨©ª«<,<©ßáÄß<^ãßá]BBc<FIJÅ,KL
READY