HP LaserJet 4200 and 4300 series printer - Start Guide

Remove the packing materials. 1) Remove the shipping bag and any

orange tape from the front and back of the printer. 2) Open the printer top

cover and remove the foam packing material inside. 3) Remove the plastic

film from the control panel display.

4) Open tray 1 and remove the orange sheet. 5) Open tray 2 and remove

all orange tape and packing materials. 6) Close both trays. Note: Save all

the packing material. You might need to repack the printer at a later date.

Install the print cartridge. 1) Remove the print cartridge from its

packaging. 2) Bend and then pull the sealing tab from the end of the print

cartridge to remove the entire length of the tape. CAUTION: Avoid

touching any black toner on the tape. If the toner gets on your clothing,

wipe it off with a dry cloth and wash the clothing in cold water. Hot water

sets the toner into the fabric.

3) Lift the printer top cover. 4) Slide the print cartridge into the printer as

far as it can go. 5) Close the top cover. Note: If the top cover does not

close, make sure the print cartridge is correctly installed.