HP LaserJet 4200 and 4300 series printer - Start Guide

4) Rotate the blue knob on the right side of the tray to the correct paper

size. (Turn the knob to “STANDARD” for LTR, A4, LGL, EXEC, A5, and JIS

B5 paper sizes, or to “CUSTOM” for custom paper sizes.)

5) Load paper into the paper tray with the top edge of the paper facing the

front edge of the tray. Make sure that the paper is flat at all four corners

and that the top of the stack is below the maximum-height indicators.

CAUTION: Do not fan the paper. Fanning can cause misfeeds. 6) Slide

the tray back into the printer.

Connect an interface cable. To connect the printer directly to a

computer: 1) Connect an IEEE 1284-compliant (size “B”) parallel cable

between the parallel port on the computer and the parallel port on the

printer. (Note: A parallel cable is not included.) 2) Snap the wire clips into

place to secure the cable at the printer.

To connect the printer to an Ethernet 10/100 Base-T network: Connect a

network cable between the HP Jetdirect print server and a port for the

network.