HP LaserJet 4200 and 4300 series printer - Start Guide

13 14

Set the control panel language. Use the (Up arrow) and (Down

arrow) to scroll to a language you want and press (Select) to select it.

(To change the language after it has been set, see the use guide on the

CD-ROM).

Test the printer. To verify that the printer is operating correctly, print a

configuration page. 1) Press (Select) to enter the menus. 2) Use the

(Up arrow) and (Down arrow) to scroll to INFORMATION and press

(Select). 3) Use the (Up arrow) and (Down arrow) to scroll to

PRINT CONFIGURATION and press (Select).

Note: If the configuration page does not print, make sure that there are no

messages (other than READY) on the control panel display, that the Ready

light (top light) is on, and that no other lights are on or blinking. Make sure

that paper is loaded and that the paper tray is properly adjusted. Make

sure that the print cartridge is installed correctly.

Install the printing software. Procedures for software installation vary

according to the operating system and the network environment. Insert the

CD-ROM into the CD-ROM drive. When the installation wizard starts,

follow the instructions. See the Readme (read4300) on the CD-ROM if the

installation wizard does not start or for detailed installation information.