printed on recycled paper hp LaserJet 4200 copyright © 2002 Hewlett-Packard Company printed in Germany start http://www.hp.com/support/lj4200 http://www.hp.com/support/lj4300 4200n 4200tn 4200dtn 4200dtns 4200dtnsl hp LaserJet 4300 4300n 4300tn 4300dtn 4300dtns 4300dtnsl *Q2431-90911* *Q2431-90911* Q2431-90911 Back Cover - A4 Width (8.268 in.) x LETTER Height (11 in.) Front Cover - A4 Width (8.268 in.) x LETTER Height (11 in.
© Copyright Hewlett-Packard Company 2002 All Rights Reserved. Except as allowed by copyright laws or herein, reproduction, adaptation, or translation without prior written permission is prohibited.
1 HP LaserJet 4200/4200n/4200tn/4200dtn/4200dtns/4200dtnsl HP LaserJet 4300/4300n/4300tn/4300dtn/4300dtns/4300dtnsl 412 mm (16.2 inches) 1045 mm (41.1 inches) HP LaserJet 4200/ 4200n/4300/4300n WARNING! The printer is heavy. To prevent physical injury, two people should lift and move the printer. Prepare the location. Place the printer in a well-ventilated room on a sturdy, level surface. Allow space around the printer, including 2 inches (50 mm) of space around the printer for ventilation.
3 1 6 5 8 2 7 4 English 3 5) Software and documentation on CD-ROM; 6) Optional 500-sheet feeder*; 7) Optional stacker* or stapler/stacker*; 8) Optional duplexer*; *This item is included with some models; it is available for all other models as an optional accessory. Check the package contents. Make sure that all the parts are included. 1) Printer; 2) Right-angle power cord; 3) Control panel overlay (This part might already be installed on the printer.
4) Open tray 1 and remove the orange sheet. 5) Open tray 2 and remove all orange tape and packing materials. 6) Close both trays. Note: Save all the packing material. You might need to repack the printer at a later date. Remove the packing materials. 1) Remove the shipping bag and any orange tape from the front and back of the printer. 2) Open the printer top cover and remove the foam packing material inside. 3) Remove the plastic film from the control panel display.
7 1 6 4 8 2 9 3 5 English 7 6) Duplexer for two-sided printing; 7) 1500-sheet feeder*; 8) Stacker or Stapler/stacker; 9) Storage cabinet *The printer supports a maximum of two optional feeders (two 500-sheet feeders or one 500-sheet feeder and one 1,500-sheet feeder). Install any optional accessories. Use the separate installation instructions to install any accessories that you have purchased with the printer.
4 5 5) Load paper into the paper tray with the top edge of the paper facing the front edge of the tray. Make sure that the paper is flat at all four corners and that the top of the stack is below the maximum-height indicators. CAUTION: Do not fan the paper. Fanning can cause misfeeds. 6) Slide the tray back into the printer. 4) Rotate the blue knob on the right side of the tray to the correct paper size.
English English 10 2 Connect the right-angle power cord. 1) Check the voltage rating on your printer (located under the top cover). The power supply will be either 110 to 127 Vac or 220 to 240 Vac, 50/60 Hz. (This is the second time you are checking the voltage.) 2) Make sure the power switch is in the off (“0”) position. 2) Connect the right-angle power cord between the printer and a grounded power strip or ac outlet.
13 14 Set the control panel language. Use the (Up arrow) and (Down arrow) to scroll to a language you want and press (Select) to select it. (To change the language after it has been set, see the use guide on the CD-ROM). Test the printer. To verify that the printer is operating correctly, print a configuration page. 1) Press (Select) to enter the menus. 2) Use the (Up arrow) and (Down arrow) to scroll to INFORMATION and press (Select).
English 16 17 Test the software installation. Print a page from any program to make sure the software is correctly installed. Note: If installation fails, reinstall the software. If reinstallation fails, see the Readme on the CD-ROM, see the support flyer that came in the printer box, or visit http://www.hp.com. In the Select your country/region field at the top, select your country/region and click . Click the Support block. Register your printer.
10
17 16 18 11
14 13 15 12
10 2 12 11 13
4 5 9 1 14
7 1 6 4 8 2 9 3 5 7 8 2 3 1 15
5 6 4 2 3 5 16
3 6 5 1 8 2 7 4 3 4 5 10 1 11 6 8 2 12 3 4 9 7 14 13 17
HP LaserJet 4200/4200n/4200tn/4200dtn/4200dtns/4200dtnsl HP LaserJet 4300/4300n/4300tn/4300dtn/4300dtns/4300dtnsl 1 412 mm (16.2 inches) 1045 mm (41.1 inches) HP LaserJet 4200/ 4200n/4300/4300n 547 mm (21.5 inches) 2 HP LaserJet 4200tn/ 4200dtn/4200dtns/4300tn/ 4300dtn 670 mm (26.4 inches) 1045 mm (41.1 inches) HP LaserJet 4200dtns/ 4200dtnsl HP LaserJet 4300dtns/ 4300dtnsl 740 mm (29.
hp LaserJet 4200 copyright © 2002 Hewlett-Packard Company start http://www.hp.com/support/lj4200 http://www.hp.com/support/lj4300 4200n 4200tn 4200dtn 4200dtns 4200dtnsl hp LaserJet 4300 4300n 4300tn 4300dtn 4300dtns 4300dtnsl *Q2431-90911* *Q2431-90911* Q2431-90911 Back Cover - A4 Width (8.268 in.) x LETTER Height (11 in.) Front Cover - A4 Width (8.268 in.) x LETTER Height (11 in.
