HP Photosmart 140 series - (English) Reference Guide

hp photosmart 140 series
chapter 1
14
paper information
You can print on photo paper, plain paper, or index cards. Your printer supports
the following paper types and sizes:
load the paper
1 Open the paper tray door and push it down as far as it will go.
2 Place a stack of paper on the paper tray and slide it underneath the output
guide.
– The printer prints on the side of the paper that is facing up. If you are
using photo paper, load the paper with the glossy side up. If you are
using tabbed paper, load the paper into the paper tray so the tab
feeds into the printer first.
– Load 10 to 20 sheets of photo paper or index cards.
– Use one type and size of
paper at a time. Do not mix
paper types or sizes in the
paper tray.
3 Move the paper width guide on
the paper tray to fit close to the
left edge of the paper without
bending the paper. This helps
the paper feed straight into the
printer.
Tip: With paper other than HP
premium plus photo paper, you
may experience paper feeding
or ejecting problems. Try loading
fewer sheets of paper at a time
and make sure the edges of the
paper stack are lined up.
Type Size Purpose
Photo paper 4 x 6 inches (10 x 15 cm) Printing photos
Photo paper with tab 4 x 6 inches with 0.5 inch tab
(10 x 15 cm with 1.25 cm tab)
Printing borderless photos
Index cards 4 x 6 inches (10 x 15 cm) Printing drafts, calibration
pages, and test pages
Hagaki cards 3.94 x 5.83 inches (100 x 148 mm) Printing photos
A6 cards 4.13 x 5.85 inches (105 x 148.5 mm) Printing photos
L-size cards 3.5 x 5 inches (90 x 127 mm) Printing photos
L-size cards with tab 3.5 x 5 inches with 0.5 inch tab
(90 x 127 mm with 12.5 mm tab)
Printing borderless photos
Output guidePaper width guide