Quick start

12
裝入 10x15 公分 (4x6 吋) 相紙
Load 10x15 cm (4x6 inch) photo paper
1. 提起出紙匣。
2. 按下「版面」按鈕以選取無框相片版面。
3. 將相片匣紙張長度導板拉出，並盡可能的將相片匣紙張寬度導
板靠左側滑入。
4. 將列印面朝下，在相紙匣裡放入最多 20 張 10x15 公分
（4x6 英吋）的相紙。
5. 調整相片匣紙張長度導板與紙張寬度導板，使其緊靠紙張邊緣
但不會使紙張彎曲。
6. 將相片匣滑塊朝印表機背面推入，直到停止移動。此時，從相
片匣視窗看過去，將會看不見相片匣。
7. 放下出紙匣。
1. Raise the Out tray.
2. Ensure that the photo tray slider is pulled away from the printer.
3. Pull out the Photo tray paper-length guide and slide the Photo
tray paper-width guide as far to the left as it will go.
4. Place up to 20 sheets of 10x15 cm (4x6 inch) photo paper in
the Photo tray so the side to be printed on faces down.
5. Adjust the Photo tray paper-length guide and paper-width guide
to fit close to the edges of the paper without bending the paper.
6. Push the Photo tray slider toward the back of the printer until it
stops. The Photo tray disappears from view in the Photo tray
window.
7. Lower the Out tray.
3
出紙匣
Out tray
紙張長度導板
Paper-length guide
紙張寬度導板
Paper-width guide
相片匣滑塊已銜接
Photo tray slider engaged