HP LaserJet 9050 - Software Technical Reference (External)

Any entry that is greater than the maximum limits of the width and height control is rounded down to
the maximum valid entry, while any entry that is smaller than the minimum limits of the width and
height control is rounded up to the minimum valid entry.
If units are in millimeters, the custom media-size range minimum is the limit rounded up to the
nearest whole millimeter. The custom media-size range maximum is the limit rounded down to the
nearest whole millimeter. Any non-numerical entry reverts to the last valid entry. Width and height
entries are validated when the focus has changed.
The resolution of each control is one millimeter or one-tenth of an inch, depending on the current
measurement units.
Units
To change measurement units, select one of the radio buttons in the Units group box (either Inches
or Millimeters).
Custom width and height control limits
The minimum media size for the HP LaserJet 9050 printer is 76.2 x 127 mm (3 x 5 inches) and the
maximum is 215.9 x 355.6 mm (8.5 x 14 inches). The following table summarizes media size limits
for each media-handling device.
Table 4-2 PCL 6 custom media sizes
Tray Dimensions Minimum Maximum
Tray 1 (multipurpose) Width 98 mm (3.86 inches) 312 mm (12.3 inches)
Height 190.5 mm (7.5 inches) 470.0 mm (18.5 inches)
Tray 2 (500-sheet) Width 148 mm (5.83 inches) 297 mm (11.69 inches)
Height 210 mm (8.27 inches) 432 mm (17 inches)
Tray 3 (500-sheet) Width 148 mm (5.83 inches) 297 mm (11.69 inches)
Height 210 mm (8.27 inches) 432 mm (17 inches)
Tray 4 (2000-sheet)
Width 182 mm (7.16 inches) 297 mm (11.69 inches)
Height 210 mm (8.27 inches) 432 mm (17.0 inches)
Duplexing unit Width 148 mm (5.83 inches) 312 mm (12.28 inches)
Height 210 mm (8.27 inches) 470 mm (18.5 inches)
Use Different Paper/Covers
When the Use Different Paper/Covers check box is selected and different options are configured,
the Size is:, Source is:, and Type is: menus change, offering a variety of options. For more
information, see the
Use Different Paper/Covers section in this chapter of the guide.
Source Is
The Source is: setting specifies the source tray to use for printing a document. The list of source
trays depends on the printer accessories. Any optional source trays that are installed through the
Device Settings tab also appear here.
HP PCL 6, HP PCL 5e, and PS Emulation Unidriver features 177
HP unidrivers for
Windows