HP LaserJet 42X0/43X0 Series - (Multiple Language) 1500-sheet Tray Install Guide

CAUTION Do not fan the paper. Fanning can
cause misfeeds.
Load paper into the feeder. The height of the
stack must not exceed the fill marks on the
paper guides (callout 1), and the front edge
of the stack must be aligned with the arrows
(callout 2).
To take advantage of all the feeder
functions, the printer driver on the printer’s
host computer must be configured to
recognize the feeder. For Windows
®
, go to
the printer Properties window. On the Device
Settings tab, select the check box for the
1500-sheet feeder.
Close the door on the feeder.
To verify that installation is complete, print a
configuration page from the control panel.
Press
to open the printer menus. Press
to select INFORMATION, and then press
. Press to select PRINT
CONFIGURATION, and then press
.
Connect the cables to the rear of the printer
(callout 1). Turn the printer power on (callout
2).
Note There might be additional cables that
were connected to the printer that are not
shown in this illustration. Make sure that you
connect
all of the cables that were previously
connected to the printer.
hp LaserJet 4250/4350 series
1
Make sure that the configuration page lists
the 1500-sheet feeder as an installed
accessory. If the feeder is not listed on the
configuration page, see the use guide on the
CD-ROM that came with the printer.
5
HP LaserJet Information Engineering