130] - Calibrate my printer [Windows]

1. Load your paper into the printer and launch the HP Designjet RIP software.

The color calibration must be performed whenever:

• A printhead is changed

• A new combination of paper type and printmode is loaded which has not been previously

calibrated, see note.

• The environmental conditions change (for example, temperature or humidity)

• You note deterioration in the quality of prints.

Note: To check if your media type and print mode have already been calibrated:

Setup menu > Default Settings… > Color Calibration

2. To start the calibration process, go to Setup menu > Automatic Color Calibration…:

• Media: Select the media that is loaded on the printer.

• Quality: Select the quality in which you are going to print.

• Media Source: Select the method that the media is loaded.

3. Click Calibrate.

4. The printer will print and measure the linearization target. If you see a checkmark at the bottom of

the page, the calibration was successful.