HP xw Workstations - Diskette Drive Installation

2. Insert the diskette drive in the bracket, and secure the diskette drive by inserting two M3 screws in the

rear most holes.

NOTE: This step only applies to HP xw8200 Workstation.

3. Slide the drive into the bay. For the HP xw4300 Workstation, HP xw4200 Workstation, and HP

xw4100 Workstation, you must add four screws to secure the diskette drive to the chassis.

4. Connect a data cable from the system board to the diskette drive and connect the power cable from the

power supply to the diskette drive. Depending on your system, the location of the system board

connector and the correct power cable to use might be different. Refer to the Service and Technical

Reference Guide for your HP Workstation for product-specific information.