HP xw9300 Workstation - Setting Up SATA RAID

10. Tab to the Stripping Block to select the size (4K, 8K, 16K, 32K, 64K, 128K, Optimal). The
default is Optimal.
11. Use the up and down arrow keys to set the block size.
Sscreen 2 nVidia RAID Utility
Tab to Free Disks
12. Select the drives to be in the array.
13. Use the up and down arrow keys to highlight the drive for the array.
14. Use the right arrow key to add drives to the array.
15. Ensure the correct number of drives are selected per Table 1 above.
16. Press F7 to finish the RAID array configuration.
17. Select Y to clear the disk data.
18. The RAID Array configuration status will display the array information.
19. Press CNTL-X to exit the nVidia RAID Utility.
Screen 3 nVidia RAID Utility - Define a New Array
Set the Boot Order
20. Reboot the system and enter Setup (F10) again.
21. Enter Storage and then the Controller Order.
22. Use the arrow keys to move the pointer to NVIDIA STRIPE.
23. Use the left arrow key to change the order to First.
24. Place the OS install CD in the optical drive:
3