Troubleshooting Guide

2–8 www.hp.com Troubleshooting Guide
Troubleshooting Without Diagnostics
Computer powered off
automatically and the
Power LED flashes Red
two times, once every
second, followed by a
two second pause, and
the computer beeps two
times.
Processor thermal
protection activated:
A fan may be blocked or
not turning.
OR
The heatsink is not
properly attached to the
processor.
1. Ensure that the computer air vents
are not blocked and the
processor cooling fan is running.
2. Reboot the system and observe if
there are any POST messages
stating that one or more of the
fans are not detected. If a fan is
not detected during POST, unplug
the unit, open the chassis and
ensure that the all the fans are
plugged in correctly.
3. If fan is plugged in and seated
properly, and the POST message
still appears, then replace the
processor fan.
4. Reseat processor heatsink and
verify that the fan assembly is
properly attached. See the
appropriate Service Reference
Guide for instructions on how to
reinstall the heatsink. Correct
heatsink installation is critical to
proper system operation.
5. Contact an authorized reseller or
service provider.
Solving General Problems (Continued)
Problem Cause Solution