Technical data

nPartition System Overviews
frupower Command
HP System Partitions Guide: Administration for nPartitions, rev 5.1 104
frupower Command
The /usr/sbin/frupower command turns on, turns off, or displays the
current status of power for cells and I/O chassis in nPartition servers.
NOTE The frupower command (and Partition Manager) permits you to power
on or off inactive cells and I/O chassis that are assigned to the current
nPartition or are not assigned to any nPartition.
See the frupower (1M) manpage for details. Also refer to the section
Powering Cells and I/O Chassis On and Off on page 314 for procedures
and examples.
Syntax frupower [ -d | -o | -f ] -c cell [-c...]
frupower [ -d | -o | -f ] -i IOchassis [-i...]
frupower [-d] -C [-l cabinet ] [-l...]
frupower [-d] -I [-l cabinet ] [-l...]
Options -d Display power status of the specified cells or I/O
chassis. This is the default.
-o Power on the specified cells or I/O chassis.
The -o and -f options are mutually exclusive. The -o
and -f options are unavailable with -C and -I.
-f Power off the specified cells or I/O chassis.
-c cell
The specified cell is powered on/off or the power
status is displayed.
A cell can be specified either in the local
( cabinet/slot ) or global ( cell_ID ) format.
-i IOchassis
The specified IOchassis is powered on/off or the power
status is displayed.
-C Display power status of all cells. By default the scope
is the entire complex if the -l option is not specified.