User's Manual

3-3
Getting Started With Access Point Configuration
Getting Started With Access
Point Configuration
3. Type configure to enter global configuration mode.
4. Type password manager password to create a password for the Manager,
where password can consist of between 3 and 16 alphanumeric characters
and is case sensitive.
To Set the Access Point’s IP Address
By default, the access point is configured to automatically receive IP
addressing from a Dynamic Host Configuration Protocol (DHCP) server.
However, if you are not using a DHCP server to configure IP addressing, use
the CLI to manually configure the IP values.
1. From the global configuration mode, type interface ethernet to access the
Ethernet interface-configuration mode.
2. Type show ip to display the access point’s default IP configuration,
including IP address, subnet mask, and default gateway. The following
illustration shows the default settings.
3. To manually assign an IP address, type ip address ip-address netmask,
where ip-address is the access point’s IP address and netmask is the
network mask for the network. If managing the access point from another
subnet, you must also set the default gateway with the ip default-gateway
ProCurve RSVLC-0501#configure
ProCurve RSVLC-0501(config)#
ProCurve RSVLC-0501(config)#password manager 1AB2F
ProCurve RSVLC-0501(config)#
ProCurve RSVLC-0501(config)#interface ethernet
ProCurve RSVLC-0501(ethernet)#
ProCurve RSVLC-0501(ethernet)# show ip
IP Address Information:
System Host Name ProCurve-RSVLC-0501
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Default Gateway not set
DHCP Client Enabled
DNS Information (Obtained from DHCP):
Domain Name Suffix not set
Primary DNS Server not set
Secondary DNS Server not set
ProCurve RSVLC-0501(ethernet)#