User's Manual

3-5
Getting Started With Access Point Configuration
Getting Started With Access
Point Configuration
1. From any command level, type the show radio command followed by the
radio number to display the radio’s configuration, including the radio
mode, radio channel, and operation status. The following illustration
shows the default settings.
2. Type configure to enter global configuration mode, and then type radio 1
to access the wireless interface-configuration mode for radio 1.
3. Set the channel through which the access point’s radio 1 (802.11b/g)
communicates with its wireless clients. The default setting is to statically
set the operating channel number. Type static-channel number, where
number can be from 1 to 14, depending on the wireless regulations speci-
fied by your country. Otherwise, type channel-policy best to have the
access point automatically select the best available channel.
4. To set the primary Service Set Identifier (SSID) for the access point. Type
ssid 1 to enter SSID interface configuration for the primary SSID interface.
Then type ssid identifier, where identifier can consist of up to 32 alphanu-
meric characters and is case sensitive.
ProCurve RSVLC-0501# show radio 1
Description Radio 1 - 802.11g
Base MAC 00:14:C2:A5:1D:60 Status Enabled
Mode 802.11g Channel-Policy best
Channel 8 SSIDs Supported 16
TX-Power(%) 100 Local Wls Bridge Fltr Disabled
Antenna Mode diversity Antenna(s) In Use internal
RTS-Threshold 2347 Fragment-Threshold 2346
WMM QoS on Beacon-Interval(K-us) 100
SVP QoS [add-in-future-SSID]
Rate-Limiting (Disabled)
Rate-Limit(packets/second) 50 Burst-Limit(packets/second) 75
802.11h (Enabled) Radar-Detection Enabled
Blocked-Time not set Quiet Duration Interval not set
TX-Mitigation not set Quiet Period (Beacon) not set
AP-Detection (Disabled)
Passive Scan Interval [add-in-future]
ProCurve RSVLC-0501#
ProCurve RSVLC-0501#configure
ProCurve RSVLC-0501(config)#radio 1
ProCurve RSVLC-0501(radio1)#
ProCurve RSVLC-0501(radio1)#static-channel 11
ProCurve RSVLC-0501(radio1)#
ProCurve RSVLC-0501(radio1)# ssid 1
ProCurve RSVLC-0501(radio1-ssid1)# ssid APRSVLC-0501
ProCurve RSVLC-0501(radio1-ssid1)#