User's Manual

5-9
Troubleshooting
Restoring Custom and Factory Default Configurations
Troubleshooting
2. Once the LEDs shut off, release the reset button. The LED shutdown is
followed by all LEDs flashing rapidly (about once per second).
3. Release the clear button while the LEDs are still flashing. The configura-
tion sets to the custom default settings and the AP is rebooted.
To restore a custom default configuration using the console, execute the erase
startup-config command from the console command prompt.
To execute the factory default reset on the access point, perform these steps:
1. Press the reset and clear buttons simultaneously.
2. Once the LEDs shut off, continue pressing both buttons.
The LED shutdown is followed by all LEDs flashing rapidly (about 10
times per second).
3. Release the clear button while the LEDs are still flashing.
The configuration sets to the factory default settings and the AP is
rebooted.
To restore the factory default configuration using the console, execute the
copy factory-default startup-config command from the console command
prompt.