User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
1-6
Introducing the ProCurve Wireless Access Point 10ag
Back of the Access Point
Introducing the ProCurve
Wireless Access Point 10ag
Back of the Access Point
LAN Port
The access point includes one 10/100Base-TX port. This port uses the “HP Auto
MDIX” feature, which means that you can use either a straight-through or a
crossover twisted-pair cable to connect the access point to a switch, a hub or
a workstation.
Power Connector
The access point does not have a power switch; it is powered on when
connected to the AC power adapter, and the power adapter is connected to
an active AC power source.
The access point's power adapter automatically adjusts to any voltage
between 100-240 volts and either 50 or 60 Hz. There are no voltage range
settings required.
Caution Use only the AC power adapter supplied with the access point. Use of other
adapters, including adapters that came with other ProCurve Networking
products, may result in damage to the equipment.
Reset to Default
button
ProCurve Wireless Access Point 10ag
Network port
10/100Base-TX RJ-45
port and PoE input
DC power connector