User Manual

2-11
Installing the Access Point
Installation Procedures
Installing the Access Point
2. Check the LEDs on the access point as described below.
When the access point is powered on, it performs its system initialization.
The system initialization takes between 30 seconds and one minute to
complete.
LED Behavior
During the system initialization:
• The Power LED first turns on immediately, then one LAN LED (either
10M or 100M, depending on the speed of the connected device) turns
on, and then the two Wireless LEDs turn on and off several times
during the initialization phase.
When the system initialization completes successfully:
•The Power LED remains green.
•The LAN and Wireless LEDs on the front panel of the access point go
into their normal operational mode:
– If the RJ-45 network port and radio interfaces are connected to
active network devices, the LEDs should be blinking at a rate
proportional to the traffic rate. If there is no network activity, the
LEDs should still be blinking at approximately 5 second intervals.
– If the RJ-45 network port is not connected to an active network
device and the radio interfaces are disabled, the LEDs should be
off.
If the LED display is different than what is described above, the system
initialization has not completed correctly. Refer to Chapter 6
, “Trouble-
shooting” for diagnostic help.
Wireless LEDs
Ethernet LED
Power LED