User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
3-6
Getting Started With Access Point Configuration
Default Configuration Parameters
Getting Started With Access
Point Configuration
Table 3-2.
Parameter Default Description
Username admin The name of the manager.
Password password The password for the manager.
IP Address 192.168.1.11 IP address compatible with your network.
Subnet Mask 255.255.255.0 Subnet mask compatible with your network.
Default Gateway not set IP address of the next-hop gateway node for network traffic that needs
to be able to reach off-subnet destinations.
Radio 1 Mode 802.11g The operating mode for Radio 1.
Radio 2 Mode 802.11a The operating mode for Radio 2.
SSIDs wireless-g - SSID 1
wireless-a - SSID 2
The Service Set Identifier (SSID) for the access point interface, which
is broadcast in the beacon frames.
Note: The IP address and subnet mask assigned to the access point must be compatible with the IP addressing used
on your network. For more information on IP addressing, see “
Configuring Basic Settings” on page 4-1.