User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
4-5
Setting Up the Access Point
Configuring Basic Wireless Settings
Setting Up the Access Point
Figure 4-3. Add Wireless Profile Page
To create a new wireless profile:
1. On the menu, click Wireless Settings under Setup. The SSID List page
appears.
2. Click Add. The Wireless Settings page appears.
3. In Wireless Network Name (SSID), type a unique SSID (not used on
your network) that you want to assign to the wireless profile.
4. In SSID Broadcast, select Enable if you want to allow all wireless
stations within the range of the access point to see the SSID. Otherwise,
click Disable.
5. In Mode, select the wireless mode that you want this wireless profile to
use. Available options include:
• g and b: Select to allow connections from 802.11g and 802.11b clients
only.
• a: Select to allow connections from 802.11a clients only.
6. In Channel/Frequency, select the wireless channel and frequency that
you want this wireless profile to use. The range of channels and frequen-
cies available depends on the wireless mode that you selected.