User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
4-18
Setting Up the Access Point
Configuring the Security Settings
Setting Up the Access Point
Configuring WPA (TKIP)
This security profile uses TKIP as the encryption cipher and 802.1X as the
authentication mechanism. In this way, each station is going to utilize a unique
master key to derive the encryption between the access point and station.
Figure 4-10. WPA (TKIP) Options
To use WPA (TKIP):
1. On the menu, click Security Settings. The Security Settings page
appears.
2. In SSID, select the SSID for which you want to set the security profile.
3. Under Security Options, click WPA (TKIP).
4. In the Key Update Interval box, define the time interval (in seconds)
for regenerating a group key.
5. Under RADIUS Server, configure the RADIUS server settings:
• RADIUS Server IP: Type the IP address of the RADIUS server on
the network.
• RADIUS Port: Type the User Datagram Protocol (UDP) port number
used by the RADIUS server for accounting messages. Setting the port
number to zero disables RADIUS authentication.