User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
5-2
Managing the Access Point
Viewing Device Information
Managing the Access Point
Figure 5-1. Information Page
The Information page displays three types of device information:
■ Access Point Information
• MAC Address: The physical layer address for the Ethernet port
interface
• Region: Shows the country/region that was set on the Basic Setting
page
• Firmware Version: Shows the version number for the runtime soft-
ware
■ Current IP Settings
• IP Address: Shows the IP address of the management interface for
this device
• Subnet Mask: Shows the subnet mask configured for the manage-
ment interface
• Default Gateway: Show the IP address of the next-hop gateway node
for network traffic that needs to be able to reach off-subnet destina-
tions.Gateway address
• DHCP Client: Shows whether the built-in DHCP client is Enabled or
Disabled.
■ Wireless Network Information
• Wireless Network Name (SSID): SSID configured for this wireless
network