User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
5-6
Managing the Access Point
Upgrading the Firmware
Managing the Access Point
Note Upgrading the firmware will not change the current configuration of the
access point. The access point configuration is contained in a separate file
that can also be transferred, for example, for archive purposes or to be used
in another access point of the same model. It is recommended that you save
a copy of the configuration file before upgrading your access point software.
See “
Backing Up and Restoring Configuration” on page 5-8 for information on
saving the access point’s configuration file.
Figure 5-3. Upgrade Firmware Page
Upgrade Procedure
To upgrade the access point firmware:
1. On the menu, click Upgrade Firmware. The Upgrade Firmware page
appears.
2. Click Browse. The Choose File dialog box appears.
3. Go to the folder where you saved the upgrade file, select the file, and then
click Open. The Choose File dialog box disappears.
4. Click Upgrade.
When the firmware update is complete, the Access Point reboots itself,
and then prompts you to log on to the Web interface again.
5. Log on to the Web interface.