User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
5-7
Managing the Access Point
Viewing the List of Associated Stations
Managing the Access Point
6. On the menu, click Information.
7. Check the value for Firmware Version and verify that it shows a later
version than what was installed before the update.
Viewing the List of Associated Stations
You can view which wireless stations are associated with the access point
anytime by accessing the Station List page on the Web interface.
To access the page, click Station List on the menu. A table appears, which lists
the following information about each associated wireless station:
■ MAC address: Displays the MAC or physical address of the associated
wireless station
■ Channel: Displays the current channel on which the wireless station is
receiving broadcast signal
■ Data rate: Displays the transmission speed at which the wireless station
is receiving data from the access point
■ RSSI: Displays the received signal strength of the wireless station on the
current wireless channel
Figure 5-4. Station List Page