User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
6-5
Troubleshooting
Diagnosing with the LEDs
Troubleshooting
5 The
10/100Base-TX
network
connection is not
working
properly.
Try the following procedures:
• Verify that both ends of the cabling, at the access point and the connected device, are
connected properly.
• Verify the connected device and access point are both powered on and operating
correctly.
• Verify duplex operation (see page 6-1).
• If these procedures don’t resolve the problem, try using a different cable.
Tip Problem Solution