User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
A-1
Specifications
A
Specifications
Physical
Electrical
Note: Power can also be provided to the access point through the Ethernet
port based on IEEE 802.3af Power over Ethernet (PoE) specifications. The
access point is a Class 3 device, that is, the maximum power required is in the
range of 6.49 to 12.95 watts. When both PoE is provided and the adapter is
plugged in, PoE is turned off.
Environmental
Width: 178 mm
Depth: 103 mm
Height: 34 mm
Weight: 285 g
Adapter
AC voltage: 100-240 volts, 0.5A, 50/60 Hz
DC voltage: 12 volts, 1.25A (max)
Power consumption: 15 watts (max)
Operating Non-Operating
Temperature: 0°C to 40°C (32°F to 104°F) PoE mode -40°C to 70°C (-40°F to 158°F)
Relative humidity:
(non-condensing)
15% to 95% 10% to 90%
Maximum altitude: 3.05 Km (10,000 ft)