User's Manual
Table Of Contents
- Contents
- 1 Deploying the M220
- 2 Using Quick setup
- 3 Managing the M220
- 4 Working with wireless communities and authentication
- 5 Wireless configuration
- 6 Creating WDS links
- 7 Configuring Ethernet, IP, and VLAN settings
- 8 Clustering multiple M220s
- 9 Maintenance
- 10 Tools
- 11 Support and other resources
28 Managing the M220
SNMP configuration
The M220 provides a robust SNMP v1/v2 implementation supporting both industry-standard
MIB II objects and HP-specific MIB objects. Read-only access is supported.
Select Management > SNMP to open the SNMP configuration page.
SNMP
Use this checkbox to enable/disable the SNMP agent. By default, the SNMP agent is enabled.
If you disable the agent, the M220 will not respond to SNMP requests.
Read-only community name
Confirm read-only community name
This is the password that controls read-only access to SNMP information on the M220. A
network management program must supply this name when attempting to get SNMP
information from the M220. By default, the name is set to public.
Supported MIBs
The M220 supports the following MIBs and MIB objects:
Standard MIBs
The following standard MIBs are supported:
• BRIDGE-MIB (802.1d) • SNMP-TARGET-MIB
• ENTITY-MIB (RFC 2737) • SNMP-USM-DH-OBJECTS-MIB
• IANAifType-MIB • SNMPv2-CONF
• IEEE802dot11-MIB • SN M P v 2- M I B ( R F C 2418 )
• IF-MIB • SNMPv2-SMI
• INET-ADDRESS-MIB • SNMPv2-TC
• RADIUS-ACC-CLIENT-MIB • SNMPv2-TM
• RFC1155-SMI • RFC4688
• RFC1213-MIB • IP-MIB
• RFC-1215 • TCP-MIB
• SNMP-FRAMEWORK-MIB • UDP-MIB
• SNMP-NOTIFICATION-MIB • UCD-SNMP-MIB