Installation Guide

December 16, 2004 HP Confidential 2
FCC Regulatory Statements
USA-Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by tuning the equipment off and on, the
user is encouraged to try and correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Caution: Exposure to Radio Frequency Radiation.
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this
device and all persons.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
When FCC ID:B94RSVLD0403 is installed in the final system where the antenna location is less than 20 cm separation distance to the body of user,
additional equipment authorization applied.
FCC ID label on the final system must be labeled with " Contains FCC ID:B94RSVLD0403 " or " Contains transmitter module FCC
ID:B94RSVLD0403".