User's Manual
Table Of Contents
- Contents
- Use your Opal for printing
- Use your Opal with your computer
- Install the software
- General Windows Bluetooth information
- Basic operations
- Configure Bluetooth
- Security
- Troubleshooting
- Technical information
- Technical specifications
- Limited warranty statement
- Customer care
- Environmental product stewardship program
- Regulatory Information
- Notice to users in the European Economic Area
- Notice to users in Argentina
- Notice to users in Brazil
- Notice to users in Indonesia
- Notice to users in Japan
- Notice to users in Korea
- Notice to users in Mexico
- Notice to users in Pakistan
- Taiwan DGT warning statement
- Notice to users in Taiwan
- Notice to users in Russia
- Notice to users in South Africa
- Declaration of conformity (European Economic Area)
- Index
Installing the HP Opal
1. Locate the host USB port on your printer or all-in-one. It will usually be located in the
front and is shaped like the USB port on your computer. It may be called a camera
or Pictbridge port on your printer.
2. Remove the cap from the Opal and insert it into the port.
LED behavior
The LED on the Opal tells you what is going on.
• Blinking—This is the default state and means the device is installed and has power.
• Rapid blinking—A sending device is “Discovering” the Opal.
• On steady—The Opal is receiving data.
Opal access modes
Access modes determine how easily a Bluetooth sending device can print to a printer.
The access modes are defined by the following settings:
• Accessibility
• Security level
Chapter 1
6 Use your Opal for printing