User's Manual

OEM Installation Guidance Document
For HP SDGOB-1504
FCC ID: B94SDGOB1504; IC: 466D-SDGOB1504
Page 2 of 8
user is encouraged to try and correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
System integrators must include the FCC ID on the end product.
FCC Radio-Frequency Exposure & Approval Conditions:
1. For Mobile applications, a separation distance of at least 20 cm must be maintained
between the antenna of this device and all persons. This device must not be co-
located or operating in conjunction with any other antenna or transmitter.
2. Transmitting antenna(s) can only be installed at the display section of computer.
When this device is installed other than notebook computers, at least 20 cm
separation distance shall be maintained between the transmitting antenna(s) to the
body of user or nearby person.
3. The antenna(s) used for this transmitter must not be collocated or operating in
conjunction with any other antenna or transmitter within a host device, except in
accordance with FCC multi-transmitter product procedures.
4. Only those antennas with same type and lesser gain filed under this FCC ID number
can be used with this device.
5. The regulatory label on the final system must include the statement: “Contains FCC
ID: B94SDGOB1504 “or using electronic labeling method as documented in KDB
784748.
6. The final system integrator must ensure there is no instruction provided in the user
manual or customer documentation indicating how to install or remove the transmitter
module except such device has implemented two-ways authentication between
module and the host system.
7. The final host manual shall include the following regulatory statement:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a