Maintenance and Service Guide

USB connector
Description Spare part number
USB connector (includes cable) 729741-001
Before removing the USB connector, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the rear cover (see
Rear cover on page 14).
5. Remove the battery (see
Battery on page 16).
Remove the USB connector:
1. Disconnect the USB connector cable (1) from the system board.
2.
Remove the Phillips PM1.75×4.0 screw (2) that secures the USB connector to the
display assembly.
3. Remove the USB connector and cable (3).
Reverse this procedure to install the USB connector.
Removal and replacement procedures
23