HP SNMP / Serial Port Card Installation Instructions

HP SNMP / Serial Port
Card
Installation Instructions
© Copyright 2006 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
May 2006 (Fourth Edition)
Part Number 201544-004
NOTE: This document is an update to Chapter 2,
"Installation," in the HP SNMP / Serial Port Card
Reference Guide.
Overview
A UPS with an installed HP SNMP / Serial Port Card provides
a power management solution for workstations and other
peripheral equipment.
Precautions
See the Important Safety Information guide (included in the
UPS kit) before installing this product.
Save these instructions. This document contains important
safety instructions that should be followed during the
installation of this option card.
WARNING: A risk of personal injury from
electric shock and hazardous energy levels
exists. The installation of options and routine
maintenance and service of this product
must be performed by individuals who are
knowledgeable about the procedures,
precautions, and hazards associated with AC
power products.
NOTE: The rating label on the device provides the
class (A or B) of the equipment. Class B devices have
a Federal Communications Commission (FCC) logo or
FCC ID on the label. Class A devices do not have an
FCC logo or FCC ID on the label. After determining
the class of the device, refer to the user guide for
complete regulatory compliance notices.
Kit contents
• This document and documentation CD
• HP Enterprise Infrastructure Solutions Management Pack
CD
• Warranty information
• SNMP / Serial Port Card
• Configuration cable
Required tools
No. 2 Phillips screwdriver