HP SNMP / Serial Port Card Installation Instructions

Installing the SNMP / Serial
Port Card
1. Install HP Power Manager agents on every server or
workstation protected by the host UPS.
To download the latest software version, see the HP
website (http://www.hp.com/go/rackandpower
).
2. Perform a normal system shutdown on all devices
connected to the host UPS.
3. Place the UPS in Standby mode (from Operate mode or
Configure mode) by pressing the Standby button (1).
4. Unplug the UPS.
WARNING: To reduce the risk of personal
injury from electric shock, avoid operating
the UPS while it is disconnected from the
source of electrical power.
5. Remove the Serial Port Card located on the rear of the
UPS.
6. Install the SNMP / Serial Port Card. Be sure to seat it
properly.
7. Power up the UPS.
8. Connect the network cable to the RJ-45 connector on the
SNMP / Serial Port Card.
Configuring the SNMP / Serial
Port Card
For configuration instructions, see the HP SNMP / Serial Port
Card Reference Guide located on the documentation CD or
HP website (http://www.hp.com/go/rackandpower
).
Updating the firmware
To update the option card firmware, see the HP website
(http://www.hp.com/go/rackandpower
).