Maintenance and Service Guide

Solid-state drive
Description Spare part number
256-GB 700813-001
128-GB 700812-001
32-GB 700811-001
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
Bottom cover on page 33).
5. Disconnect the battery cable from the system board (see
Battery on page 35).
Remove the solid-state drive:
1. Remove the two Phillips PM2.0×4.5 screws (1) that secure the solid-state drive to the top cover.
(The solid-state drive tilts up.)
2.
Remove the solid-state drive (3) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
40 Chapter 4 Removal and replacement procedures