Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

Bezel Blanks
Description Spare part number
3.5-inch bezel blank, jack black 583653-001
5.25-inch bezel blank, jack black 570838-001
On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch drive bays that need to
be removed before installing a drive. To remove a bezel blank:
1. Remove the access panel (
Computer Access Panel on page 126)
2. Remove the front bezel (
Front Bezel on page 127)
3. To remove a bezel blank, push the two retaining tabs that hold the bezel blank in place towards
the outer right edge of the bezel (1) and slide the bezel blank back and to the right to remove it
(2).
Figure 7-3 Removing a Bezel Blank
System Board Connections
Refer to the following illustrations and tables to identify the system board connectors for your model.
Figure 7-4 8200 Elite Series System Board Connections
128 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis