Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

Power Switch/LED Assembly
Description Spare part number
Power switch/LED assembly 646828-001
1. Prepare the computer for disassembly (Preparation for Disassembly on page 73).
2. Remove the access panel (
Computer Access Panel on page 126).
3. Remove the front bezel (
Front Bezel on page 127).
4. Remove the front fan (
Front Fan Assembly on page 149).
5. Disconnect the cable from the system board connector labeled PB/LED.
6. With the computer on its side, press on the tabs on the bottom of the assembly (1) to disengage
the assembly from the chassis, and then rotate the bottom of the assembly upward (2) to
remove it from the chassis.
Figure 7-30 Removing the power switch/LED
7. Pull the assembly away from the chassis while threading the cable through the hole in front of
the chassis.
152 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis