Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

TV Tuner or WLAN Module
The procedure to remove and replace the TV tuner module and the WLAN module are similar. The
image in this section illustrates a TV tuner module. Use the same basic procedure the remove a
WLAN module.
Description Spare part number
HP TV Tuner Kit (includes hardware) 613990-001
802.11a/b/g/n WLAN module 631954-001
1. Prepare the computer for disassembly (Preparation for Disassembly on page 206).
2. Remove the computer access panel (
Access Panel on page 207).
3. Remove the optical drive (
Removing the Optical Drive on page 216).
4. Remove the hard drive (
Hard Drive on page 219).
5. Remove the optical drive rail (
Optical Drive Rail on page 223).
6. Remove the heat sink (
Heat sink on page 227).
7. Disconnect the antenna cable from the connector on the module (1).
8. Remove the two screws (2) that secure the module to the system board.
Figure 9-27 Removing the TV tuner module
9. Lift the module to a 45 degree angle, and then remove the module from the connector by pulling
it away at an angle.
To install the TV tuner module or WLAN module, reverse the removal procedure. Make sure the
antenna cable is correctly routed.
232 Chapter 9 Removal and Replacement Procedures – Ultra-Slim Desktop (USDT) Chassis