NTI R NETWORK TECHNOLOGIES INCORPORATED 1275 Danner Dr Tel:330-562-7070 Aurora, OH 44202 Fax:330-562-1999 www.networktechinc.
TRADEMARK XTENDEX is a registered trademark of Network Technologies Inc in the U.S. and other countries. COPYRIGHT Copyright © 2007 by Network Technologies Inc, all rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.
Table of Contents Introduction...................................................................................................................................................................... 1 Features....................................................................................................................................................................... 1 Types of User Input Devices Supported:.................................................................................................
INTRODUCTION The ST-C5USBV-300 USB Extender (XTENDEX) is designed to enable the relocation of a monitor, USB keyboard, and USB mouse from a USB CPU or NTI USB KVM switch by as much as 300 feet via CAT5 cable in addition to having a monitor, USB keyboard, and USB mouse connected locally. It is extremely simple to install and has been thoroughly tested to insure reliable performance.
Limitations • The XTENDEX will only work with USB keyboards and mice, other USB devices are not supported. • PS/2 devices can be connected to the XTENDEX through an NTI USB-PS/2 adapter, however the translation keys described on page 15 will not function in this application. • The XTENDEX can be used between two cascaded NTI switches, but the master switch in the configuration will not be able to list the CPUs connected to the extended slave.
FEATURES AND FUNCTIONS 4 5 3 - 6 + R Network Technologies Inc Network Technologies Inc - R XTENDEX USB NTI NTI XTENDEX USB 2 1 + (Rear View) (Front View) ST-C5USBVA-300 (Remote Unit) + 9 NTI XTENDEX USB - R Network Technologies Inc 6 Network Technologies Inc NTI + 7 (Front View) 2b 8 - R XTENDEX USB (Rear View) 2a 2 10 11 12 ST-C5USBVA-300 (Local Unit) Audio Jack- 3.
PREPARATION FOR INSTALLATION • A location should be chosen for the monitor, mouse, and keyboard that also has space to mount the Remote Unit within the distance provided by the cables from the monitor, mouse, and keyboard. If extension cables are needed, contact NTI for the cables required. If a local user will be connected, a proper location must be chosen for these devices too. • The CAT5 cable(s) must be run to the locations where the Remote and Local Units will be placed.
INSTALLATION The Local Unit Connect to the CPU 1. Plug the cables of the Local Unit into the back of the CPU. (See Fig. 1.) a) Connect the blue 15HD cable from the Local Unit to the female VGA port on the back of the CPU. b) Connect the USB Type A cable from the Local Unit to a female USB Type A port on the back of the CPU.
USB Type A male XTENDEX USB Network Technologies Inc NTI + line out ST-C5USBVA-300 Local Unit (Rear View) (BLUE- VIDEO) ONE WILL BE MARKED "line out" ,"spkr", "headphones" OR WITH THIS SYMBOL - R AUDIO CONNECTOR (BLACK- AUDIO) USB CPU 15HD male Video Connector 3.5mm Stereo Plug Figure 2- Local unit with audio support connects to CPU Connect the Local Devices If desired, connect the local user devices to the Local Unit as shown in Fig. 3. 1.
3. If the Local Unit has audio support (ST-C5USBVA-300) , connect the cable from the local self-powered stereo speakers to the 3.5mm stereo audio jack on the Local Unit. (See Fig. 4) ST-C5USBVA-300 (Local Unit) - + NTI R Network Technologies Inc XTENDEX USB 3.
ST-C5USBV-300 Remote Unit (Front View) USB Type A Female (Rear View) + R Network Technologies Inc R XTENDEX USB - NTI Network Technologies Inc NTI - XTENDEX USB Yellow Communication LED Green Power LED + 15HD Female Video Connector CAT5 Cable to Local Unit USB Type A male USB Type A male connectors VGA Multi-Scan Monitor 15HD male Video Connector USB Keyboard USB Mouse Figure 6- Connect the Monitor and Devices to the Remote Unit 4.
Connect the CAT5 cable Connect the CAT5 cable to the “CAT5” port on the rear of the Remote Unit (see Fig. 8). (If an RJ45 wall outlet is being used, connect the other end of the extension cable to it.) When properly inserted the cable end should snap into place.
COMMAND MODE The XTENDEX has two areas of user control that can be used as needed. The user can adjust video quality (described below) , or enable/disable MAC mode (see page 11) These controls are accessed by entering Command Mode. To enter Command Mode, simultaneously press the left and right keys on the keyboard connected to the Remote Unit. The keyboard LEDs will illuminate. To exit Command Mode, press .
MAC Mode MAC Mode enables the user to connect the Local Unit to a MAC CPU. MAC Mode configures the Local Unit for passing mouse information to the MAC CPU. This is useful when the user wants to use mouse drivers provided by the mouse vendor, which allows the use of programmable functions for each mouse button. The Local Unit can be configured whenever necessary. NOTE: When the port is connected to a PC or SUN CPU, MAC Mode should be OFF (the default setting). To do this; 1. Enter Command Mode.
COMMON APPLICATIONS Figure 11 (below) illustrates three common applications for the ST-C5USBV-300 USB KVM Extender.
TECHNICAL SPECIFICATIONS Maximum Resolution w/ CAT5/5e UTP (refresh frequency 60Hz) Maximum Resolution w/ CAT5/5e STP Or CAT6 UTP (refresh frequency 60Hz) Video Compatibility Video Quality Video Coupling Video Connectors Sync Types Supported Video Signal Type Maximum Input/Output Levels Input / Output Impedance Input Horizontal Frequency Range Input Vertical Frequency Range Keyboard/Mouse Connectors Interconnect Cable Remote and Local Unit Power Operating Temperature Range ESD protection CE Mark RoHS Dimen
INTERCONNECTION CABLE WIRING METHOD The connection cable between the remote and local is terminated with RJ45 connectors and must be wired according to the EIA/TIA 568B industry standard. Wiring is as per the table and drawing below.
KEYBOARD TRANSLATION Key Equivalents Using the chart below, find the character needed to be typed on the CPU being accessed, then follow the row across for the equivalent on the keyboard being used. (See Fig. 13 on page 16 for reference.
Esc ~ ` Num Lock Backspace Tab Enter Caps Lock Shift Shift Enter Ctrl Alt Ctrl Alt Typical 101 Keyboard Esc F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 ~ ` Print Screen SysRq F12 Scroll Lock Pause Break Num Lock Backspace Tab Enter Caps Lock Shift Shift Enter Ctrl Alt Ctrl Alt Windows Logo Key Application Key Windows Logo Key Windows USB Keyboard CD Eject Key F1 esc F2 F3 F4 F5 F6 F7 F8 F9 F11 F10 ~ ` F12 F13 F14 F15 num lock delete clear = / * tab retu
TROUBLESHOOTING Each and every piece of every product produced by Network Technologies Inc is 100% tested to exacting specifications. We make every effort to insure trouble-free installation and operation of our products. If problems are experienced while installing this product, please look over the troubleshooting chart below to see if perhaps we can answer any questions that arise. If the answer is not found in the chart, please check the FAQs (Frequently Asked Questions) at our website at http://www.
INDEX CAT5 Cable Spec, 14 CAT5 LEDs, 9 Command Mode, 10 DDC support, 11 Devices Supported, 1 Installation, 5 Key Equivalents, 15 limitations, 2 MAC LED, 3 MAC Mode, 11 Specifications, 13 SUN extra keys, 15 Troubleshooting, 17 Video quality adjustment, 10 WARRANTY INFORMATION The warranty period on this product (parts and labor) is two (2) years from the date of purchase. Please contact Network Technologies Inc at (800) 742-8324 (800-RGB-TECH) or (330) 562-7070 or visit our website at http://www.
