Owner's manual

7. Enter the gatew ay in the Gateway box.

8. The DNS I P Address and Domain Na me are not used. Leave the defaults (if any).

9. Clic k Conﬁgure to save the network settings to the VLS.

10. The Updating Conﬁguration window displays (see Figure 22). Wait for it to close.

Figure 22 Updating conﬁgura tion

11 . Click Exit to close the VLS discovery utility. The Releasing Devices window displays (see Figure 23).

Figure 23 Releasing devices

Conﬁguri

ng the

VLS appliance via the default IP Address

If you c an

not or do not want to use the VLS discovery tool to conﬁgure the appliance, you can directly

connect

PC to the VLS L AN por t without the use of a switch. If the server has a Gbit connection you can

do this using a standard Category 5E cable, but if the server has a 10/100Mbit connection then you

need a special LA N cross-over cable (not included). From the directly-connected PC you can then launch

the

VLS v

the devi ce ’s default IP address (10.0.0.1).

• You may need to conﬁgure the PC net working to enable it to connect to the device’s 10.0.0.1

address (for example set the PC’s IP address to 10.0.0.2, set its netmask to 255.255.0.0, disable

proxy settings in its web browser).

• Then pe

rform the steps in "Verifying the network conﬁguration" to launch the VLS GU I (at address

10.0.

0.1) and modify the device network settings via the GUI.

Verifying the network conﬁguration

Initially the VLS Discovery tool must be used, as described in Conﬁguring the VLS appliance with the VLS

Discover y tool, to make the VLS available on your network. H owever, once the VLS is available on your

network, subsequent changes to its IP address, gateway address, and subnet mask ca n be mad e using

the

VLS GUI as shown in the following procedure.

1. In your Web browser on any PC on the network, enter the applicable IP address to access the

VLS GUI.

2. Enter the following in case-sensitive format:

Conﬁguring the VLS1000i