Owner's manual

• Retype Password Enter the password again.
NOTE:
Changing the passw ord is required.
Figure 29 Setting login information
2. Clic k Ap ply.
3. Continue the configuration process by entering the E-m ail information describe d in the next section.
Configuring E-mail alerts
The V LS continuously monitors its performance and routinely checks for disk failures. If you are using an
SMTP server you c an enable the messaging o ption, in which an E-mail is sent whenever the Status of a
volume on the Device Summary page becomes anything other than Normal (for example, changes to
Warning).
NOTE:
Messages regarding cap acity levels (Warning and Error) are only sent once.
If your mail server is able to send E-mail messages outside the company, you can also set up messaging
to
notify HP Storage Technical Support automatically whenever a critical error occurs.
To configu re m essaging
1. In the right pane, scroll down b elow the Logon Information section to locate the E-mail Noti fi cation
section, and enter the following:
• SMTP Server IP Address Using dotted decimal notation, enter the IP address of your incoming
mail
ser
ver.
• From Address Enter the E-mail address from which the alert will be sent. This address must
use the same domain as the mail server specified for S MTP Server IP Address.
• Address
for all messages Enter the E-mail address to which all alerts should be sent (for
exampl
e, the E-mail address for the network administrator or the E-mail list address for a
group of backup administrators).
• Address for c ritical messages only Enter the E-mail address to which critical alerts only
should
be
sent.
42
Configuring the VLS1000i