Owner's manual

If youare usingsoftwaredrivers, usefollowing proceduretoinstall Microsoft’siSCSI Software Initiator.
NOTE:
You do not need TO E-equipped (Transmission Control P rotocol [TCP] Offload E ngine) or special
iSCSI-capable GbE HBAs to work with software initiators. Any standard Network Interface Card (NIC)
can serve as an iSCSI network interface device; however, HP Storage strongly recommends that you
use GbE for enhanced performance.
1. Download the appropriate iSCSI initiator file for your platform from this URL:
h
ttp://www.microsoft.com/downloa ds/details.aspx?FamilyID=12cb3c1 a-15d6-4585-b385-
befd1319f825&DisplayLang=en The file name will likely end in x86fre.exe.
2. Double-click the initiator file to start installing the Microsoft iSCSI Initiator.
3. In the Software Update Installation Wizard, click Next.
4. Under Installation Options, select both Initiator Service and Software Initiator. Click Next.
5. In the License Agreement window please read the agreement, then select IAgree.Click Next.The
installation proceeds.
6. When the installation finishes, click Finish.
7. If necessary, reboot the system.
8. After the system reboots, select Start > All Programs > Microsoft iSCSI Initiator > Microsoft iSCSI
Initiator.
9. In the iSCSI Initiator Properties window, select the Discovery tab .
At this
time, no items are listed u nder Target Portals.
10. In the Target Portals section, click Add.
11 . In the Add Target Portal window, enter the IP address of your VLS. Maintain the default por t setting.
Click OK.
44
Configuring the VLS1000i