Owner's manual

Figure 35 iSCSI Name
5. If you want to use an additiona
l
level of authentication, use dotted decimal notation to enter the IP
address of the host system in the iSCSI IP Enforcement field. This is optional.
6. Continue with Creating virtual devices.
Creating vir tual devices
TheVLS1000ihas capacityfor thefollowing numbersofdevices:
• 12 virtual tape drives (total of standalone drives and drives in virtual tape lib raries)
• 6 virtual tape libraries
• 180 virtual cartridges total (up to 80 cartridges for each virtual tape library)
To select thetypeofdeviceto create, perform the following steps:
1. Open the VLS GUI. See Opening a VLS GUI session from a web browser.
2. In the GUI, select Configuration > Create Virtual Device.See Figure 36.
NOTE:
The Configuration screen defaults to the Backup Host Summary page and begins with no
devices listed. You must use Create Virtual Device.
Figure 36 Select type of device to create
3. Select thetypeof device to create byclicking either Virtual Library or VirtualStandaloneTapeDevice.
4. Continue with the next appropriate section—either Creating a standalone tape d evice or Creating
a tape library.
Creating a standalone tape device
Perform the following steps to finish creating a tape device:
1. Scroll down, if needed, in the Create Virtual Device pane until you see D evice Details ( Figure 37).
HP StorageWorks 1000i Virtual Library System
47