Owner's manual

Figure 51 Shut down conﬁrmation

6. Wait until the fans stop (this may take several minutes), then disconnect the AC line c ord from

the

power mains.

7. Unplug all connections, and label them so that you can reattach them using the same c onnection

conﬁguration.

8. If the appliance is in a rack, remove it by extending the slide rails and then releasing the slide locks.

CAUTION:

Extending a unit that has empty spaces beneath it might cause the rack to tip forward

might cause personal injury.

9. Move the appliance to the new location.

10. Connect the appliance to the network.

For more information, see Installing cables.

11 . Attach the power cord to the appliance and plug the cord in to an AC power source. Press the

power button to start the VLS.

For more information, see Powering up the VLS.

Rebooting the VLS

To reboot the appliance:

1. Verify that any backup or restore operation has completed and that the VLS is idle.

2. Open the VLS GUI. See Opening a VLS GUI session from a web browser.

3. Initiate a reboot of the VLS by selecting the GUI’s Suppor t tab, selecting S hut Down/Restart,and

clicking Restart.See Figure 5 2.

HP StorageWorks 1000i Virtual Library System