User's Manual

1
2
Figure 17 Removing the EMU
Removing the I/O modules
To remove an I/O module:
1. Grasp the I/O module handle (Figure 18-1),pressdownonthemodulelatch(Figure 18-2) and
pulltheI/Omodulestraightoutoftheenclosure(Figure 18-3).Takecarenottotiltthemoduleor
bring it in contact with the sides of the rack or other components.
2. PlacetheI/Omoduleonanantistaticsurface.
Figure 18 Removing an I/O module
Instal
ling the DS2500 in the rack
WARNING!
A DS2500 without components installed weighs approximately 11.0 kg (24 lb). Even though a single
person can lift this weight, the DS2500 is difficult to install because of its physical size. Therefore, HP
recommends that a minimum of two people install an empty DS2500 in a rack.
To install a DS2500:
1. From the front of the rack, slide the DS2500 onto the rails.
2. Secure the DS2500 to the front of the rack by tightening the four thumbscrews (Figure 19).
2500 Disk System user guide
31